Glidecam Camcrane 200

• Holds cameras up to 25 lbs at the 8 ft. length, And 30 lbs at the 6' 6" length
• Four boom length combinations: 3' 3", 4' 10", 6' 6" And 8' 1"
• Three fulcrum (balance) settings
• Can vertically boom from the floor to 10 feet when setup at the 8 ft. length (variable)
• Rotates 360 degrees via precision, low-deflection, needle roller, turntable bearing
• Mounts on the 3/8" stAndard bolt found on the majority of medium duty tripods, And some heavy duty tripods
• The Head of the Crane has 3/8" mounting holes/slots.
• The complete system weighs 19 pounds (approximately).
• Fits easily into the trunk or back of a car when not fully assembled at 3' 3" long
• Heavy barbell weights are not included.
• Fine tuning counter balance weights are included.
• Tripod is not included.
• All measurements are approximate.
• Made primarily of high-grade aluminum
• Black coat finish
• Made in USA

The Camcrane 200 mounts onto the 3/8" stAndard bolt found on the majority of medium duty tripods, And some heavy duty tripods. The Camcrane 200's Head Unit has 3/8" mounting holes/slots allowing you to attach And horizontally balance a pan/tilt, tripod head. The Head Unit can be set up in either high or low mode. The Camcrane 200 can be operated from either the Head Unit or the Weight Unit.

NOTE: A "flat plate adapter" with a 3/8" threaded stud/bolt will be needed with any heavy duty tripod that uses a bowl mount, because the Camcrane 200 will not connect directly onto a bowl mount.